The final resin cast talisman prototype was included in the parcel. Each item in the parcel has a descriptive note in each zip lock bag.
The included resin prototype had all components mounted inside clear resin to allow sculpturing the talisman shape. The final unit will be milky opaque and not clear.
The included prototype did not have a PCB included so one of the two nuts was loose and has been weakly glued in place. The final talisman will have the nut on the top side of the PCB and will not fall out because the PCB will hold it firmly in place.
The final device will be either bolted onto a custom personalised wrist strap, or will be worn around the neck as a pendant with a chain attacked to the rear of the talisman.
Power is applied to the device with a magnetic clasp once a week to recharge the device.
Talisman Development 